Accessories

 

AquaGuard HVAC Accessories AquaGuard brand products are without a doubt the best solution when a condensate management system is required, and these accessory products can help further enhance the professional quality of any HVAC installation. 
 

AquaMate In-Line Drain Clean-Out Port

The AquaMate in-line access port attaches to your primary or secondary drain line and allows easy access in the event of a clog. The AquaMate is the final touch for a truly professional installation.

AG-3176 Auxiliary Primary Pan Probe

The AG-3176 is an alternative probe to be used in conjunction with the AG-3175E water sensing system. The probe clips onto the side of the primary drain pan and monitors condensate directly inside of the pan. The versatility of this probe allows for placement anywhere on the pan incase of installations where the secondary drain is not the lowest point to which condensate will flow. Wire is rated for plenum use.

VI-4200 Vibration Isolators

The VI-4200 vibration isolators for the Goliath series secondary drain pan are made of high quality, durable rubber that can dampen the noise produced by an HVAC unit while it is in use. The VI-4200 is included with the Goliath series secondary drain pans.

VI-4300 Vibration Isolators

The VI-4300 vibration isolators for the Goliath Furnace series secondary drain pan are made of heat resistant, durable rubber that can dampen the noise produced by an HVAC unit while it is in use. The VI-4300 is included with the Goliath Furnace series secondary drain pans.

AG-MJ1 Metal Jacket Riser Kit

When local building codes require additional clearance for an HVAC furnace installation, the MJ1 Riser kit can add 1" between theGoliath Furnace pan and the furnace unit. The MJ1 mounts to the VI-4300 vibration isolator to keep noise to a minimum.

AG-3157 6' Probe Extension Cable

The AG-3157 is an extension cable that is installed between the AG-3000E control box and the probe in any AquaGuard Electronic Series condensate sensor. This cable will allow for an additional 6' of length between the control box and the probe.

AG-3177 6' Plenum Rated Probe Extension Cable

The AG-3177 is a plenum rated extension cable that is installed between the AG-3000E control box and the probe in any AquaGuard Electronic Series condensate sensor. This cable will allow for an additional 6' of length between the control box and the probe.

Disclaimer

Important: All images are copyrighted to their respective owners.